Circutor CEM-C30 series Bedienungsanleitung PDF herunterladen (Seite 30)

To write or modify the value, short press the button

repeatedly, increasing the value of the ashing digit.

When the desired value is shown on the screen, move onto the next digit with a long press on

the button, allowing the remaining values to be modied.

To validate the data, move to the last digit and long press the button; the validation screen

will appear (Figure 13) indicating that the programming value has been saved.

After a few seconds viewing the screen shown on Figure 13 , the system returns to the CO

emissions programming main screen.

Minimum value: 0.000

Maximum value: 9.000

Short press the button to access the next programming step.

4�7�10� Partial energy meter deletion

NB: It is only displayed if the partial energy display has been selected.

On this screen you select whether or not to delete the partial

energy meters.

Long press the

button to delete the energy meters. The

validation screen (

Figure 13) will be displayed next, indicating that

the energy meters were deleted correctly.

After a few seconds viewing the screen shown on Figure 13 , the system returns to the Partial

energy meter deletion programming main screen.

Short press the button to access the next programming step.

4�7�11� Exiting the setup menu

When this screen is displayed:

Long press the

button to exit the setup menu.

Short press the

button to return to the rst setup point

( “4.7.1. Impulse output weight”)

CEM-C30

Instruction Manual

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 41 42

Keine Kommentare

Circutor CEM-C30 series Bedienungsanleitung Seite 30