Circutor CDP-0 Bedienungsanleitung PDF herunterladen (Seite 27)

CDP

Instruction Manual 27

Figure 25: Single-phase installation with 1 load to connect (Load Connected).

In this situation the CDP-G maintains the system without adding or removing any

loads for a time equalling the longer of the configured “Reconnection time” and

“Min. disconnection time” variables, in order to achieve system stability (in this

case 90 minutes).

To check if this load must be disconnected, the CDP-G waits for the amount of

time programmed in the “Min. connection time” variable and then checks if the

following condition is met:

• Disconnection condition:





 

< .  

(





= 60%)  60% ≤ 20% 

this condition is NOT met  the CDP-G open the relay.

Loads

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 73 74

Keine Kommentare

Circutor CDP-0 Bedienungsanleitung Seite 27