Circutor CDP-0 Bedienungsanleitung PDF herunterladen (Seite 56)

CDP

56 Instruction Manual

• Relay 1, Relay 2, Relay 3: Configuration of the relays.

- Power : Power to be consumed by the load. If it is zero, the load is

considered to be deactivated.

- Min. connection time: Minimum time that a load must stay connected

before it can be deactivated, if required.

6.1.2.5. Data logger

(see 6.2.1. CDP AS A DATA LOGGER)

• Time between logs: time to record logs in the Data Logger: 1, 5, 10, 15

or 60 minutes.

6.1.3. Analyzers setup

It is also possible to configure the communications between the CDP and the

CVM Mini or CVM Net power analyzers (Figure 73) on the web site.

Figure 73: Setup web site: Analyzers setup.

6.1.3.1. Load analyzer

• Enable external analyzer: facilitates the use of an external analyzer rather

than the CDP as a measuring unit.

• Primary current: primary value of the load analyzer of the current

transformer.

• Device number: Peripheral number of the external analyzer.

(Only activated when the “Enable external analyzer” option is activated).

6.1.3.2. Grid analyzer

• Primary current: primary value of the grid analyzer of the current

transformer.

• Device number: peripheral number of the CVM power analyzer installed to

measure the consumption of the grid.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 73 74

Keine Kommentare

Circutor CDP-0 Bedienungsanleitung Seite 56