Circutor CVM-C10 Series Bedienungsanleitung PDF herunterladen (Seite 51)

In the case of some parameters (Table 14) you can modify the position of the decimal point.

To do so, press key after modifying the last digit and the decimal point will start ashing.

Press key repeatedly to modify the position of the decimal point.

To validate the data, press for 3 seconds and the prog icon will disappear from the display.

Press key to access the next programming step.

 Programming the connection time delay

The alarm connection delay is programmed on this screen in

seconds.

Press key

for 3 seconds to edit the delay selection. The prog

icon will be displayed on the bottom of the screen.

To enter or modify the value, press the

key repeatedly,

increasing the value of the ashing digit.

When the desired value is shown on the screen, move onto the next digit by pressing the key

to modify the other values.

If you press the key after changing the last digit, it will jump back to the rst digit so you

can modify the previously programmed values again.

To validate the data, press for 3 seconds and the prog icon will disappear from the display.

Press key to access the next programming step.

 Programming the hysteresis value

The hysteresis value, i.e., difference between the alarm

connection and disconnection value, in %, is programmed on

this screen.

Press key

for 3 seconds to edit the hysteresis value

selection. The prog icon will be displayed on the bottom of the

screen.

To enter or modify the value, press the

key repeatedly,

increasing the value of the ashing digit.

When the desired value is shown on the screen, move onto the next digit by pressing the key

to modify the other values.

If you press the key after changing the last digit, it will jump back to the rst digit so you

can modify the previously programmed values again.

To validate the data, press for 3 seconds and the prog icon will disappear from the display.

Press key to access the next programming step.

Instruction Manual

CVM-C10

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 81 82

Keine Kommentare

Circutor CVM-C10 Series Bedienungsanleitung Seite 51