Circutor CVMk2 Series Bedienungsanleitung PDF herunterladen (Seite 50)

CVM

CONFIGURATION

4.7.2.1.b Reverse conguration logic output

When a variable code corresponding to the status of an expansion card input is selected, an

alarm can be activated in one of two possible ways: direct or inverse logic.

To congure the alarms using direct logic, with respect to the input, [i.e., the alarm activates

(value = 1) when the input activates (value = 1)], the parameters should be congured as

follows:

max = 1 and min = -1.

To congure the alarms using inverse logic, with respect to the input, [i.e., the alarm activates

(value = 0) when the input deactivates (value = 1)], the parameters should be congured as

follows:

max = 0 and min = 0.

4.7.2.2. Relay outputs conguration

On this screen, equations are congured for the alarms that are applied to activate the system

outputs. Equations can be congured using AND (*) and/or OR (+) functions between one or

more of the 16 previously congured alarms (see Section 4.7.2.1. Alarm Conguration) in order

to activate each relay output.

To modify the card conguration parameters, press the EDIT button (F4). Select the output to

be congured and press SET to begin editing.

Press (F3) to return to the ALARM 01 screen (Section 4.7.2.1).

Press (F1) to return to the inputs screen (Section 4.7.2.3).

WARNING: The value 00 in the outputs activation equation means that nothing

at all should be done. Thus, it should only be entered at the end of the equation.

If the value 00 is entered at the beginning of the equation, the CVMk2 will not

make the calculation or activate the corresponding output.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 151 152

Keine Kommentare

Circutor CVMk2 Series Bedienungsanleitung Seite 50